Programmable dc Switching Power Supplies by AMREL: Programmable Switching Power Supply

Programmable dc Switching Power Supplies by AMREL: Programmable Switching Power Supply

Programmable dc Switching Power Supply

AMREL Programmable Power Division

HOME

ABOUT AMREL PD

CUSTOMIZATION

MARKETS & APPLICATIONS

SUPPORT & DOWNLOADS

NEWS & EVENTS

SPECIAL PROMOTIONS

QUESTIONS? CONTACT US

eLoad Programmable Electronic Loads

ePower Programmable
Power Supplies

ePower Rugged Military
Fixed Power Supplies

Other
Power Products

SPS Features & Benefits

SPS Specifications

SPS SERIES OF MID-POWER PROGRAMMABLE DC SWITCHING POWER SUPPLIES (3.3kW-45kW)

SPS SELECTOR GUIDE

SPS UUU X VVV - K00Z (A-panel) \| SPS UUU X VVV - K0YZ (K-panel)

Ordering Example (A-panel): SPS200X50-A00C
Description: 200Vdc, 50Adc, No Interfaces Available and 208/220Vac 3-ph AC Input
Ordering Example (K-panel): SPS200X50-K02C
Description: 200Vdc, 50Adc, GPIB & RS232 Interface and 208/220Vac 3-ph AC Input

UUU – VOLTAGE RATING
VVV – CURRENT RATING

	Y – INTERFACE	Z – AC INPUT VOLTAGE
	2 – GPIB & RS-232	C – 208/220Vac 3-ph
	E – GPIB, RS-232, USB & ETHERNET	D – 380/400Vac 3-ph
		E – 440/480Vac 3-ph

*MODELS*	Amperage						PARD1&2
Voltage	5 kW	10 kW	15 kW	20 kW	25 kW	30 kW	RMS	P–P
0-40V	0-125A	0-250A	0-375A	0-500A3	0-625A3	0-7503	20 mV	75 mV
0-60V	0-83A	0-167A	0-250A	0-333A	0-417A	0-500A	20 mV	75 mV
0-80V	0-63A	0-125A	0-188A	0-250A	0-313A	0-375A	20 mV	100 mV
0-100V	0-50A	0-100A	0-150A	0-200A	0-250A	0-300A	20 mV	100 mV
0-160V	0-31A	0-63A	0-94A	0-125A	0-156A	0-188A	25 mV	150 mV
0-200V	0-25A	0-50A	0-75A	0-100A	0-125A	0-150A	25 mV	175 mV
0-250V	0-20A	0-40A	0-60A	0-80A	0-100A	0-120A	30 mV	200 mV
0-330V	0-15A	0-30A	0-45A	0-61A	0-76A	0-91A	30 mV	200 mV
0-400V	0-12A	0-25A	0-38A	0-50A	0-63A	0-75A	40 mV	300 mV
0-600V	0-8A	0-17A	0-25A	0-33A	0-42A	0-50A	60 mV	350 mV
0-800V	0-6.2A	0-12.5A	0-18.7A	0-25A	0-31.2A	0-37.5A	80 mV	500 mV

P-P noise is measured across a 1uF capacitor at the end of a 6’ load cable with the supply operating at full load & at nominal input line voltage.
RMS noise is measured directly across the output terminals with the supply operating at full load and at nominal input line voltage.
Power level not available in 6U chassis. In 3U chassis, these power levels can be achieved up to 75kW by paralleling up to five power supplies. Note that paralleling will increase Ripple and Noise.


	AMREL MANUFACTURES THE WIDEST RANGE OF ELECTRONIC TEST EQUIPMENT ON THE MARKET INCLUDING:

eLoad dc Electronic Loads

600w to 250kW

PLA Air-cooled
Programmable dc
Electronic Loads

3kW to 250kW+

PLW Water-cooled Programmable dc Electronic Loads

LPL Low-profile
Programmable dc
Electronic Loads

Programmable dc
Electronic Loads System Solutions

System Solutions

BPL Bench-top Programmable dc
Electronic Loads

BPL Bench-top Programmable dc
Electronic Loads

60W to 300W

FEL Low-voltage Programmable dc Electronic Loads

60W to 600W

PEL Low-power Programmable dc Electronic Loads

60W to 300W

ZVL Zero-volt
Programmable dc
Electronic Loads

200W to 1.5kW

(Ethernet based)

ZVL Zero-volt
Programmable dc
Electronic Loads

200W to 1.5kW

FCL Fuel Cell
Programmable dc
Electronic Loads

ePower dc Power Supplies

MFP
Rugged Military
Fixed Power
dc Power Supplies

SPD Dual-channel Programmable dc Switch Mode Power Supplies

SPS Legacy
Programmable dc
Switch Mode Power
Supplies

1.6kW to 3kW

SPS Bravura
Programmable dc
Switch Mode Power
Supplies

SPS Bonafide
Programmable dc
Switch Mode Power
Supplies

HPS High-power Programmable dc Switch Mode Power Supplies

100W to 200W

BPD Bench-top
Programmable dc
Linear
Power Supplies

PD Single or Dual Channel Programmable dc Linear
Power Supplies

up to 200W per Channel

PDS Multi-channel
Programmable
dc Linear
Power Supplies

Copyright © 2009 AMREL All Rights Reserved 3445 Fletcher Avenue El Monte, CA 91731 Phone 626-443-6818 Fax 626-443-8600